|
How to use your PERTH therapy system?
1) Connect the applicator mat or any other applicator to the control unit
2) Connect the power supply to the control unit
3) Plug the power cable from the power supply in an outlet. Please make sure the power supply meets the voltage in your country (110 V - or 220 V).
Note: The unit is now ready for the treatment, the LED display should lid up.
Now you can select the program P1 - P5 (EMG Profi & L&T only), set the timer between 10 to 60 minutes and the level strenght indicator (on the right) on Level 1-8, according to the manual.
When you push the START button the therapy starts. The level LED's will begin to flash, except on level 1. The unit shut's automatically off, after the specified time is over and 5 minutes later the power to the control unit will turn off completely.
If you fall a sleep during the therapy session - you don't need to worry. This is just a positive sign of deep relaxation. Depending on your condition you can and should repeat the therapy session 2-3 times a day. In the cancer and bone therapy, please combine the therapy programs P1-P3 with the special cancer (P5) or bone therapy program (P4). You can begin to time each program equally. Put your attention to the therapy program P3, because this program has eight (8) therapy sequences integrated. Each of it is running for two minutes. Which means a run of 16 minutes will give you the benefit that all of the 8 therapy sequences running one time for 2 minutes. 32 min. - P3 the therapy sequences were running 2 times, etc.
Cancer & bone (cartilage) therapy: Please do not use P4 or P5 extensively! You always need to balance, harmonize and energize the meridians to boost up the immune system. Always combine with the other therapy programs (P1-P3).
If you use the head applicator, please use it only on Level 1 or 2. The head applicator is for all head-related, nerve, eye and ear diseases.
|
